You are here

Home › Forums › W2 Forum › Hydrodynamics

GUI error

Mon, 08/24/2015 - 10:36am — Kristen
I am trying to use the W2 GUI. I have my control file and my bth file processed and ready to go (via WMS). Read in another thread that WMS outputs bth files for an older version of CE-QUAL-W2 so I updated it according to the instructions in the thread (compared with an example bth file). My control file opens fine in the GUI, but my bth file causes the program to crash. It doesn't even open... If I go to "open" and navigate to the file, and double click, I get the following error: Run-time error '9': Subscript out of range Or When I click the yellow BTH button: Run-time error '53': File not found I have tried modifying the bth file as explained above or just using the file directly out of WMS. Both ways result in the same error. Can anyone help? Thanks, Kristen
Forums: 
Hydrodynamics
Mon, 08/24/2015 - 2:49pm — Amir

After opening the control file in the GUI check if they appear correctly in their locations. Look for all the components of your control file and see if they are in place. Many times you have to add an empty line to your control file to adjust them. You have to see the name of your bth file in the section belongs to it in GUI. Normally this is the cause of the error. So the first thing to check is to see if the GUI could understand the name of the "bth file" in order to open it. Secondly number of IMX and KMX. Third, the segment numbering and connection.