You are here

Home › Forums › W2 Forum › Hydrodynamics

out flow

Wed, 07/02/2008 - 12:03pm — ArtN
I am converting from version 2.04 to 3.5, differences in the outlet configuration are a concern, the following is the control card setup in 2.04 can you help on the control card for 3.5? It is Cheatham Dam and Lock ELBOT is 105.3, top layer elev is 117.3 SEL WITH SWC SWC SWC SWC SWC SWC SWC SWC SWC OFF N STRUC NSTR NSTR NSTR NSTR NSTR NSTR NSTR NSTR NST…R 1 K BOTTOM KBSW KBSW KBSW KBSW KBSW KBSW KBSW KBSW KBSW Br 1 19 SINK TYPE SINKC SINKC SINKC SINKC SINKC SINKC SINKC SINKC SINKC Br 1 LINE E STRUC ESTR ESTR ESTR ESTR ESTR ESTR ESTR ESTR ESTR Br 1 110.0 W STRUC WSTR WSTR WSTR WSTR WSTR WSTR WSTR WSTR WSTR Br 1 50.0 N OUTLET NOUT NOUT NOUT NOUT NOUT NOUT NOUT NOUT NOUT 1 O LAYER KOUT KOUT KOUT KOUT KOUT KOUT KOUT KOUT KOUT 16 N WDRWAL NWD 0 W SEGMNT IWD IWD IWD IWD IWD IWD IWD IWD IWD W LAYER KWD KWD KWD KWD KWD KWD KWD KWD KWD
Forums: 
Hydrodynamics
Thu, 07/03/2008 - 3:45pm — chris

Art, Here is how I would do it: Set NST=1 at top of control file. NSTR=1 STRIC=ON or OFF (depends if interpolation of outflow in v2.0 model was turned on) KTSTR=2 (top most active layer) KBSTR=bottom active layer at dam (unless you have reason to believe withdrawal zone starts higher up) SINKC=LINE ESTR=110.0 WSTR=50.0 chris